Light texture (light knockdown, light orange peel, etc.) means just applying a light coat. Slightly more mud and texture are applied for “medium” texture, and even more for “heavy.” The reasons to use a certain texture are personal preference and/or for a purpose such as hiding imperfections.
¼ inch sheets of drywall board are not strong enough for good support alone, but they are excellent when you need to install drywall on a slightly curved surface such as an arch. ½ inch drywall is the “standard” size. This is used for interior walls and ceilings. 5/8 inch drywall is slightly thicker and…
To skim coat means to apply a thin layer of drywall mud on ceilings or walls to create a smooth surface. It can be used to repair damage, prepare for painting, or smoothing texture. Depending on the job and homeowner’s request/needs, skim coats can be applied by hand, with a paint roller, or with a…
While all drywall is naturally fire-resistant, purple drywall board is special. It resists moisture, mold, and mildew. Some purple board help prevent scratches, scuffs, dents, and sound. Purple sheetrock is needed around wet areas including showers, bathtubs, and sinks. It can also be used for extra proofing between certain rooms.
Stomp texture is a type of decorative finish applied to walls and ceilings. It is created by applying a layer of mud or texture material to the surface and then “stomping” it with a brush or a specialized stomp pad. The process involves pressing the brush or pad into the wet compound and then pulling…
Knockdown texture is a popular finish for walls and ceilings that adds a bit of visual interest and hides imperfections. It is created by applying a watered-down joint compound to the surface and then “knocking down” the peaks with a trowel or a wide knife after it has partially dried. This results in a mottled,…
Level 0: Only construction crews see this. At this level, there is no tape, no finishing coats of mud and no corner bead necessary. This is typically requested if the setup is temporary. Level 1: These areas are not typically seen either. All joints and angles are taped, but there’s no need to cover the tape…
